Kia Sportage: Body (Interior and Exterior) / Rear Door
- Components and components location
- Repair procedures
- Rear Door Trim Components and components location
- Rear Door Trim Repair procedures
- Rear Door Inside Handle Repair procedures
- Rear Door Window Glass Components and components location
- Rear Door Window Glass Repair procedures
- Rear Door Module Components and components location
- Rear Door Module Repair procedures
- Rear Door Outside Handle Components and components location
- Rear Door Outside Handle Repair procedures
- Rear Door Latch Components and components location
- Rear Door Latch Repair procedures
- Rear Door Belt Outside Weatherstrip Repair procedures
- Rear Door Belt Inside Weatherstrip Repair procedures
- Rear Door Side Weatherstrip Repair procedures
Rear Bumper beam Assembly Repair procedures
Replacement
Put on gloves to protect your hands.
...
Components and components location
Components
1. Rear door trim
2. Rear door panel & module
3. Rear door division channel
4. Rear door fixed glass
5. Rear door body side weatherstrip
...
Other information:
Kia Sportage QL (2015-2026) Owners Manual: Main fuse
If the main fuse is blown, it must be removed as follows: 1. Turn off the engine. 2. Disconnect the negative battery cable. 3. Remove the nuts shown in the picture above. 4. Replace the fuse with a new one of the same rating. 5. Reverse these steps to reinstall the main fuse. ✽ NOTICE The ...
Kia Sportage QL (2015-2026) Service Manual: Manifold Absolute Pressure Sensor (MAPS) Description and operation
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM. By using this signal, the ECM calcul ...
Copyright © www.ksportagegl.com 2015-2026
