Kia Sportage: Mirrors / Reprogramming a single HomeLink button
To program a device to HomeLink using a HomeLink button previously trained, follow
these steps:
1. Press and hold the desired HomeLink button. Do NOT release until step 4 has
been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position
the hand-held transmitter 2-8 cm (1 to 3 inches) away from the HomeLink surface.
3. Press and hold the hand-held transmitter button (or press and “cycle” - as
described in “Canadian Programming”).
4. The HomeLink indicator light will flash, first slowly and then rapidly. When
the indicator light begins to flash rapidly, release both buttons.
The previous device has now been erased and the new device can be activated by
pushing the HomeLink button that has just been programmed. This procedure will not
affect any other programmed HomeLink buttons.
To erase the three programmed buttons (individual buttons cannot be erased):
Press and hold the left and center buttons simultaneously, until the indicator
light begins to flash (approximatel ...
During programming, your hand-held transmitter may automatically stop transmitting.
Continue to press and hold the HomeLink button (note steps 2 through 4 in the “Programming”
portion of this ...
Other information:
The AEB system is to reduce or to avoid accident risk. It recognizes the distance
from the vehicle ahead or the pedestrian through the sensors (i.e. radar and camera),
and, if necessary, warns the driver of accident risk with the warning message or
the warning alarms.
WARNING - Autonomous Eme ...
Description
An ignition coil is an induction coil in an engine's ignition system which transforms
the battery's low voltage to the high voltage needed to create an electric spark
in the spark plugs to ignite the fuel. Coils have an internal resistor while
others rely ...