Kia Sportage: Seat / Headrest (for front seat)
The driver's and front passenger's seats are equipped with a headrest for the occupant's safety and comfort.
The headrest not only provides comfort for the driver and front passenger, but also helps protect the head and neck in the event of a rear collision.
For maximum effectiveness in case of an accident, the headrest should be adjusted so the middle of the headrest is at the same height of the center of gravity of an occupant's head. Generally, the center of gravity of most people's head is similar with the height of the top of their eyes.
Also, adjust the headrest as close to your head as possible. For this reason, the use of a cushion that holds the body away from the seatback is not recommended.
WARNING - Headrest removal/adjustment
- Do not operate the vehicle with the headrests removed. Headrests can provide critical neck and head support in a crash.
- Do not adjust the headrest height while the vehicle is in motion. Driver may lose control of the vehicle.
Lumbar support
The lumbar support can be adjusted by pressing the lumbar support switch on the
side of the seat.
1. Press the front portion of the switch to increase support, or the rear portion
of the switch ...
Adjusting the height up and down
To raise the headrest, pull it up to the desired position (1). To lower the headrest,
push and hold the release button (2) on the headrest support and lower the headrest
to the desired position ...
Other information:
Kia Sportage QL (2015-2026) Owners Manual: Warning message
• This warning message may appear when : - There are foreign substances on the rear bumper or inside the rear bumper. - The vehicle carries a trailer or carrier on the rear. - Driving in rural areas with little traffic or open terrains such as wide expanse of desert. - There is heavy snow ...
Kia Sportage QL (2015-2026) Service Manual: Front Seat Belt Buckle Repair procedures
Replacement 1. Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly") 2. Disconnect the front seat belt buckle connector wiring (A). 3. Remove the front se ...
