Kia Sportage: Installing a Child Restraint System (CRS) / Securing a child restraint with the LATCH anchors system
To install a LATCH-compatible child restraint in either of the rear outboard
seating positions:
1. Move the seat belt buckle away from the lower anchors.
2. Move any other objects away from the anchors that could prevent a secure connection
between the child restraint and the lower anchors.
3. Place the child restraint on the vehicle seat, then attach the seat to the
lower anchors according to the instructions provided by the child restraint manufacturer.
4. Follow the child restraint instructions for properly adjusting and tightening
the lower attachments on the child restraint to the lower anchors.
WARNING
Take the following precautions when using the LATCH system:
- Read and follow all installation instructions provided with your child
restraint system.
- To prevent the child from reaching and taking hold of unretracted seat
belts, buckle all unused rear seat belts and retract the seat belt webbing behind
the child. Children can be strangled if a shoulder belt becomes wrapped around
their neck and the seat belt tightens.
- NEVER attach more than one child restraint to a single anchor. This
could cause the anchor or attachment to come loose or break.
- Always have the LATCH system inspected by your authorized Kia dealer
after an accident. An accident can damage the LATCH system and may not properly
secure the child restraint.
✽ NOTICE
The recommended maximum weight for the LATCH system is 65 lbs. (30 kg). When
selecting a proper child restraint, consider that the maximum total weight of the
child plus the child restraint should be less than 65 lbs (30 kg).
As a guide, the MAX child restraint weight should be determined by the following
calculation: Child Restraint Weight = 65 - (child's total weight in lbs.)
The LATCH system holds a child restraint during driving and in an accident. This
system is designed to make installation of the child restraint easier and reduce
the possibility of improperly inst ...
First secure the child restraint with the LATCH lower anchors or the seat belt.
If the child restraint manufacturer recommends that the top tether strap be attached,
attach and tighten the top t ...
Other information:
Description
The fuel pump control module (FPCM) is installed on the right side of the fuel
tank and controls the DC motor mounted inside the low pressure fuel pump.The
module compares instantaneous fuel pressure information measured by the fuel
pressure sensor (FPS) with tar ...
Opening the fuel filler lid
1. To open the fuel filler lid, press the 3 o`clock position edge of the fuel
filler lid.
✽ NOTICE
The fuel filler lid will open when driver door is unlocked.
2. Pull the fuel filler lid (1) out to fully open.
3. To remove the fuel tank cap (2), turn it count ...