Kia Sportage: Installing a Child Restraint System (CRS) / Securing a child restraint seat with "Tether Anchor" system

Kia Sportage QL (2015-2019) Owners Manual / Safety features of your vehicle / Child restraint system (CRS) / Installing a Child Restraint System (CRS) / Securing a child restraint seat with "Tether Anchor" system

First secure the child restraint with the LATCH lower anchors or the seat belt. If the child restraint manufacturer recommends that the top tether strap be attached, attach and tighten the top tether strap to the top tether strap anchor.

Child restraint system top tether anchorages are located on the back of the rear seatbacks.

WARNING

Take the following precautions when installing the tether strap:

To install the tether anchor:

1. Route the child restraint tether strap over the child restraint seatback. Route the tether strap under the head restraint and between the head restraint posts, or route the tether strap over the top of the vehicle seatback. Make sure the strap is not twisted.

2. Connect the tether strap hook to the tether anchor, then tighten the tether strap according to the child seat manufacturer’s instructions to firmly secure the child restraint to the seat.

3. Check that the child restraint is securely attached to the seat by pushing and pulling the seat forward and from side-to-side.

Securing a child restraint with the LATCH anchors system
To install a LATCH-compatible child restraint in either of the rear outboard seating positions: 1. Move the seat belt buckle away from the lower anchors. 2. Move any other objects away from the an ...

Securing a child restraint with a lap belt or lap/shoulder belt
When not using the LATCH system, all child restraints must be secured to a vehicle rear seat with the lap part of a lap/shoulder belt. Automatic locking mode Since all passenger seat belts move ...

Other information:

Kia Sportage QL (2015-2019) Service Manual: MDPS ECU Repair procedures


Replacement 1. Disconnect the battery negative cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash pad lower panel") 3. Disconnect the MDPS ECU connector (A). ...

Kia Sportage QL (2015-2019) Service Manual: Intake Air Temperature Sensor (IATS) Repair procedures


Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within ...

Copyright © www.ksportagegl.com 2015-2019