Kia Sportage: Electronic parking brake (EPB) / Releasing the parking brake
To release the EPB (electronic parking brake), press the EPB switch while doing
the following:
- Have the ignition switch or engine start/stop button in the ON position.
- Depress the brake pedal.
- The shift lever must be in P (Park).
Make sure the brake warning light goes off.
To release EPB (electronic parking brake) automatically:
- Shift lever in P (Park) With the engine running depress the brake pedal
and shift out of P (Park) to R (Reverse) or D (Drive).
- Shift lever in N (Neutral) With the engine running depress the brake pedal
and shift out of N (Neutral) to R (Reverse) or D (Drive).
- Automatic Transaxle
1. Start the engine.
2. Fasten the driver's seat belt.
3. Close the driver's door, engine hood and tailgate.
4. Depress the accelerator pedal while the shift lever is in R (Rear), D (Drive)
or manual mode.
Make sure the brake warning light goes off.
✽ NOTICE
- For your safety, you can engage the EPB even though the ignition switch
or engine stop/start button is in the OFF position, but you cannot release it.
- For your safety, depress the brake pedal and release the parking brake
manually with the EPB switch when you drive downhill or when backing up the
vehicle. Do not follow the above procedure when driving on a flat level ground.
The vehicle may suddenly move forward.
✽ NOTICE
If the parking brake warning light is still on even though the EPB has been
released, have the system checked by an authorized Kia dealer.
CAUTION
Do not drive your vehicle with the EPB applied. It may cause excessive brake
pad and brake rotor wear.
EPB (electronic parking brake) may be automatically applied when:
- The EPB is overheated
- Requested by other systems
✽ NOTICE
If the driver turns the engine off by mistake while Auto Hold is operating,
EPB will be automatically applied. (Vehicles equipped with Auto Hold)
To apply the EPB (electronic parking brake):
1. Depress the brake pedal.
2. Pull up the EPB switch.
Make sure the warning light comes on.
Also, the EPB is applied automatically if the Auto Hold ...
If you try to drive off depressing the accelerator pedal with the EPB
applied, but the EPB doesn't release automatically, a warning will sound and
a message will appear.
If the driver ...
Other information:
If engine doesn't turn over or turns over slowly
1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake
is set.
2. Check the battery connections to be sure they are clean and tight.
3. Turn on the interior light. If the light dims or goes out when you operate
the ...
Description
The heated steering wheel system improves the thermal comfort of the driver
by heating the steering wheel when manually selected.
Heated pad
Specifications
Item
Specification
Voltage
13.5 V ± ...