Kia Sportage: SRSCM / Side Impact Sensor (SIS) Description and operation

Kia Sportage QL (2015-2026) Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Description and operation

Description

•	Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH) and two rear SIS which are installed in the rear pillar (LH and RH).

•	Pressure Side Impact Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.

•	Side Impact Sensor is also called A-SIS because it detects acceleration.

•	SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when the collision occurred.

Front Impact Sensor (FIS) Repair procedures

Removal 1. Disconnect the battery negative terminal, and wait for at least thirty seconds before beginning work. 2. Disconnect the ...

Side Impact Sensor (SIS) Components and components location

Components 1. Pressure side impact sensor (P-SIS) 2. Rear Gravity Side Impact Sensor (R-SIS) 3. Front Gravity Side Impact Sensor (G-SIS) ...

Other information:

Kia Sportage QL (2015-2026) Service Manual: Troubleshooting

Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ball joint Low tire pressure No power assist Correct Rep ...

Kia Sportage QL (2015-2026) Service Manual: Rear Washer Switch Repair procedures

Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. [Left Handle Drive] Switch Switch position Swit ...