Kia Sportage: Cylinder Block / Rear Oil Seal Repair procedures

Kia Sportage QL (2015-2026) Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures

Removal

1.	Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle")

2.	Remove the drive plate. (Refer to Cylinder Block - "Drive Plate")

3.	Remove the rear oil seal(A).

Installation

Install rear oil seal.

(1)	Apply engine oil to a new oil seal lip.

(2)	Using SST (09231-H1100, 09214-3K100) (B) and a hammer, tap in the oil seal (A) until its surface is flush with the rear oil seal retainer edge.

2.	Install the drive plate. (Refer to Cylinder Block - "Drive Plate")

3.	Install the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle")

Drive Plate Repair procedures

Removal and Installation 1. Remove the automatic transaxle . (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. ...

Piston and Connecting Rod Repair procedures

Disassembly In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and in ...

Other information:

Kia Sportage QL (2015-2026) Service Manual: Cowl Cross Bar Assembly Repair procedures

Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove inter ...

Kia Sportage QL (2015-2026) Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures

Inspection Air bag module If any improper parts are found during the following inspection, replace the airbag module with a new one. Never attempt to measure the circuit resistance of the airbag modul ...