Kia Sportage: Engine Control System / Rail Pressure Sensor (RPS) Description and operation

Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.

Rail Pressure Sensor (RPS) Specifications

Specification Pressure Output Voltage (V) [Vref=5V] bar [MPa (kgf/cm², psi)] 0 0 (0, 0) ...

Rail Pressure Sensor (RPS) Schematic diagrams

Circuit Diagram Terminal Information Terminal Illustration Terminal Function No. Function Connected ...

Other information:

Kia Sportage QL (2015-2026) Service Manual: Front Oil Seal Repair procedures

Replacement 1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pulley") 2. Remove the front oil seal (A). 3. Install the crankshaft front oil se ...

Kia Sportage QL (2015-2026) Service Manual: Components and components location

Components Location 1. Front propeller shaft 2. Center bearing bracket 3. Rear propeller shaft ...