Kia Sportage: If you have a flat tire (With tire mobility kit) / Distributing the sealant
11. Immediately drive approximately 4~6 miles (7~10 km or, about 10 min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed
of 12 mph (20 km/h).
While driving, if you experience any unusual vibration, ride disturbance or noise,
reduce your speed and drive with caution until you can safely pull off of the side
of the road.
Call for road side service or towing.
When you use the Tire Mobility Kit, the tire pressure sensors and wheel may be
stained by sealant. Therefore, remove the tire pressure sensors and wheel stained
by sealant and we recommend that inspect at an authorized Kia dealer.
- Detach the speed restriction label (1) from the sealant bottle (2), and place
it in a highly visible place inside the vehicle such as on the steering wheel to
remind the driver not to drive too ...
1.After driving approximately 4 ~ 6 miles (7 ~ 10 km or about 10 min), stop at
a safe location.
2.Screw the connection hose (10) of the compressor to the valve stem
3.Plug the compressor power c ...
Other information:
If the following conditions occur while Active ECO is operating, the system operation
is limited even though there is no change in the ECO indicator.
When the coolant temperature is low: The system will be limited until
engine performance becomes normal.
When driving up a hill: The system ...
Inspection
1.
Check the tire pressure.
17(inch) : 245+7 kPa (35 + 1.0 psi)
18(inch) : 245+7 kPa (35 + 1.0 psi)
19(inch) : 245+7 kPa (35 + 1.0 psi)
Tire Rotation
Checking For Pull And Wander
If the steering pulls to on ...