Kia Sportage: Wipers and washers / Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever is held in this position.
OFF : Wiper is not in operation
INT : Wiper operates intermittently at the same wiping intervals. Use this mode in light rain or mist. To vary the speed setting, turn the speed control knob.
LO : Normal wiper speed
HI : Fast wiper speed
✽ NOTICE
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
If you do not remove the snow and/or ice before using the wiper and washer, it may damage the wiper and washer system.
Wipers and washers
Windshield wiper/washer
Rear window wiper/washer
A : Wiper speed control (front)
· MIST – Single wipe
· OFF – Off
· INT – Intermittent wipe
· LO – Low wiper speed
· HI ...
Front windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wipe ...
Other information:
Kia Sportage QL (2015-2025) Owners Manual: LCD Display Control
The LCD display modes can be changed by using the control buttons on the steering wheel. (1) : MODE button for change the LCD MODES (2) / : MOVE scroll switch for select the items (3) OK : SET/RESET button for set the items or reset the items ...
Kia Sportage QL (2015-2025) Service Manual: Rear Oil Seal Repair procedures
Removal 1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. (Refer to Cylinder Block - "Drive Plate") 3. ...
