Kia Sportage: Features of your vehicle / Windshield defrosting and defogging
WARNING - Windshield heating
Do not use the
or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and the windshield could cause the outer surface of the windshield to fog up,
causing loss of visibility. In this case, set the mode selection to the
position and fan speed control to the
lower speed.
- For maximum defrosting, set the temperature control to the extreme right/hot
position and the fan speed control to the highest speed.
- If warm air to the floor is desired while defrosting or defogging, set
the mode to the floor-defrost position.
- Before driving, clear all snow and ice from the windshield, rear window,
outside rear view mirrors, and all side windows.
- Clear all snow and ice from the hood and air inlet in the cowl grill to
improve heater and defroster efficiency and to reduce the probability of fogging
up the inside of the windshield.
■ Example
Each symbol and specification on the air conditioning refrigerant label is represented
below :
1. Classification of refrigerant
2. Amount of refrigerant
3. Classification of Compre ...
To defog inside windshield
1. Set the fan speed to the desired position.
2. Select desired temperature.
3. Select the or
position.
4. The outside (fresh) air and air conditioning will be sele ...
Other information:
Depress the brake pedal.
Shift into N (Neutral) with an Automatic Transaxle.
Press the CANCEL switch.
Decrease the vehicle speed lower than the memory speed by 12 mph (20 km/h).
Decrease the vehicle speed to less than approximately 15 mph (25 km/h).
Each of these actions will cancel ...
If the main fuse is blown, it must be removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the nuts shown in the picture above.
4. Replace the fuse with a new one of the same rating.
5. Reverse these steps to reinstall the main fuse.
✽ NOTICE
The ...