Kia Sportage: Heater / Temperature Control Actuator Description and operation
The heater unit includes mode control actuator and temperature control actuator.
Located in the heater unit, the temperature control actuator regulates the temperature
in the following procedures.
Signal from control unit adjusts the position of the temperature door by operating
the temperature switch. Then the temperature will be regulated by the hot/cold
air ratio decided by the position of the temperature door.
Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation by confirmation logic as follows;
1.
Entering
(1)
Se ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
...
Other information:
When the tire pressure monitoring system warning indicators are illuminated,
one or more of your tires is significantly under-inflated.
If the telltale illuminates, immediately reduce your speed, avoid hard cornering
and anticipate increased stopping distances. You should stop and check your ...
Removal
[Not applied for EPB]
Brake Pad
1.
Remove the rear wheel and tire (A) from front hub.
Tightening torque:
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)
...