Kia Sportage: Heater / Mode Control Actuator Description and operation
Located in the heater unit, the mode control actuator adjusts the position of
the mode door by operating the mode control actuator according to the signal
from the A/C control unit.
Pressing the mode select switch shifts the mode control actuator in the order
of Vent → Bi-Level → Floor → Mix.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify ...
Other information:
Component Location
1. Compressor
Components
[THETA Engine]
1. Clutch Bolt
2. Limiter Bolt
3. Limiter & Hub Assembly
4. Snap Ring
5. Pulley
6. Compressor Assembly
[R ...
Inspection
1.
Connect the KDS/GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Pressure [kPa (kgf/cm², psi)]
Output Voltage (V)
50 ...