Kia Sportage: Vehicle stability management (VSM) / Malfunction indicator
The VSM can be deactivated even if you don’t cancel the VSM operation by pressing
the ESC OFF button. It indicates that a malfunction has been detected somewhere
in the Electric Power Steering system or VSM system. If the ESC indicator light
(
) or EPS warning light remains on,
take your vehicle to an authorized Kia dealer and have the system checked.
✽ NOTICE
- The VSM is designed to function above approximately 13 mph (22 km/h)
on curves.
- The VSM is designed to function above approximately 6 mph (10 km/h)
when a vehicle is braking on a split-mu surface. A split-mu surface is made
of two surfaces which have different friction forces.
- The Vehicle Stability Management system is not a substitute for safe driving
practices but a supplementary function only. It is the responsibility of the
driver to always check the speed and the distance to the vehicle ahead. Always
hold the steering wheel firmly while driving.
- Your vehicle is designed to activate according to the driver’s intention,
even with installed VSM. Always follow all the normal precautions for driving
at safe speeds for the conditions – including driving in clement weather and
on a slippery road.
✽ NOTICE
For maximum protection, always wear your seat belt. No system, no matter how
advanced, can compensate for all driver error and/or driving conditions. Always
drive responsibly.
This system provides further enhancements to vehicle stability and steering responses
when a vehicle is driving on a slippery road or a vehicle detects changes in coefficient
of friction between r ...
A vehicle has the tendency to roll back on a steep hill when it starts to go
after stopping. The Hill-start Assist Control (HAC) prevents the vehicle from rolling
back by applying the brakes autom ...
Other information:
Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, move the lever to this (MIST) position and
release it. The wipers will operate continuously if the lever is held in this position.
OFF : Wiper is not in operation
INT : Wiper operates intermittently at ...
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door quadrant inner cover (A).
3.
Disconnect the power door mirror connector from the harness.
...