Kia Sportage: Tires and wheels / Low aspect ratio tire

Kia Sportage QL (2015-2026) Owners Manual / Maintenance / Tires and wheels / Low aspect ratio tire

Low aspect ratio tires, whose aspect ratio is lower than 50, are provided for sporty looks.

Because the low aspect ratio tires are optimized for handling and braking, it may be more uncomfortable to ride in and there is more noise compare with normal tires.

CAUTION

Because the sidewall of the low aspect ratio tire is shorter than the normal, the wheel and tire of the low aspect ratio tire is easier to be damaged. So, follow the instructions below.

- When driving on a rough road or off road, drive cautiously because tires and wheels may be damaged. And after driving, inspect tires and wheels.
- When passing over a pothole, speed bump, manhole, or curb stone, drive slowly so that the tires and wheels are not damaged.
- If the tire is impacted, we recommend that you inspect the tire condition or contact an authorized Kia dealer.
- To prevent damage to the tire, inspect the tire condition and pressure every 1,900 miles (3,000 km).

Radial-ply tires
Radial-ply tires provide improved tread life, road hazard resistance and smoother high speed ride. The radial- ply tires used on this vehicle are of belted construction and are selected to complem ...

Fuses
A vehicle’s electrical system is protected from electrical overload damage by fuses. This vehicle has 2 (or 3) fuse panels, one located in the driver’s side panel bolster, the other in the ...

Other information:

Kia Sportage QL (2015-2026) Service Manual: SRS Control Module (SRSCM) Repair procedures


Removal 1. Remove the Ignition from the vehicle. 2. Disconnect the battery negative terminal and wait for at least thirty seconds before beginning work. 3. Remove the floor console. (Refer to ...

Kia Sportage QL (2015-2026) Owners Manual: License plate lamp bulb replacement


1. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing. 2. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 3. Remove the bulb from bulb-socket by pulling it out. 4. Insert a ...

Copyright © www.ksportagegl.com 2015-2026