Kia Sportage: Engine Control System / Fuel Pressure Control Valve (FPCV) Repair procedures

Kia Sportage QL (2015-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Pressure Control Valve (FPCV) Repair procedures

Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
3.
Measure resistance between the fuel pressure regulator valve terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
  
Fuel Pressure Regulator Valve can't be replaced separately, it should be replaced with the High pressure fuel pump.
(Refer to Fuel System - "High pressure fuel pump")
Installation
  
Fuel Pressure Regulator Valve can't be replaced separately, it should be replaced with the High pressure fuel pump.
(Refer to Fuel System - "High pressure fuel pump")
Fuel Pressure Control Valve (FPCV) Schematic diagrams
Circuit Diagram Terminal Information Terminal Illustration Terminal Function No. Function Connected ...

Fuel Pressure Control Valve (FPCV) Troubleshooting
Signal Waveform ...

Other information:

Kia Sportage QL (2015-2026) Service Manual: Repair procedures


General Inspection Before and after servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. ...

Kia Sportage QL (2015-2026) Service Manual: Thermostat Repair procedures


Removal and Installation    Removal of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat. ...

Copyright © www.ksportagegl.com 2015-2026