Kia Sportage: Warning lights / Electronic Brake force Distribution (EBD) System Warning Light
.png)
These two warning lights illuminate at the same time while driving:
• When the ABS and regular brake system may not work normally. In this case, have your vehicle inspected by an authorized Kia dealer.
WARNING - Electronic Brake force Distribution (EBD) System Warning Light
When both ABS and Parking Brake & Brake Fluid Warning Lights are on, the brake system will not work normally and you may experience an unexpected and dangerous situation during sudden braking thereby increasing the risk of a crash and injury. In this case, avoid high speed driving and abrupt braking. Have your vehicle inspected by an authorized Kia dealer as soon as possible.
✽ NOTICE - Electronic Brake force Distribution (EBD) System Warning Light
When the ABS Warning Light is on or both ABS and Parking Brake & Brake Fluid Warning Lights are on, the speedometer, odometer, or tripmeter may not work. Also, the EPS Warning Light may illuminate and the steering effort may increase or decrease.
In this case, have your vehicle inspected by an authorized Kia dealer as soon as possible.
Anti-lock Brake System (ABS) Warning Light
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON
position.
- It illuminates for approximately 3 seconds and then goes off.
When there ...
Electronic Power Steering (EPS) Warning Light
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON
position.
- It remains on until the engine is started.
When there is a malfunction w ...
Other information:
Kia Sportage QL (2015-2022) Owners Manual: Changing a tire with TPMS
If you have a flat tire, the Low Tire Pressure telltale will come on. Have the flat tire repaired by an authorized Kia dealer as soon as possible or replace the flat tire with the spare tire. CAUTION - Repair Agents Never use a puncture-repairing agent not approved by Kia to repair and/or in ...
Kia Sportage QL (2015-2022) Service Manual: Overhead Console Lamp Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect the ne ...
