Kia Sportage: Theft-alarm system / Disarmed stage
The system will be disarmed when
• The doors (and liftgate) are unlocked with the transmitter (or smart key) or
the ignition key.
After depressing the unlock button, the hazard warning lights will blink and
the chime will sound twice (in smart key) to indicate that the system is disarmed.
After depressing the unlock button, if any door (or liftgate) is not opened within
30 seconds, the system will be rearmed.
✽ NOTICE
- Avoid trying to start the engine while the alarm is activated. The
vehicle starting motor is disabled during the theft-alarm stage. - If the system
is not disarmed with the transmitter, insert the key into the ignition switch,
turn the ignition switch to the ON position and wait for 30 seconds. Then the
system will be disarmed.
- If the system is not disarmed with the smart key, press the engine start/stop
button with smart key. The side with the lock button should contact the engine
start/stop button directly.
- If you lose your keys, consult your authorized Kia dealer.
CAUTION - Adjusting alarm system
Do not change, alter or adjust the theft-alarm system because it could cause
the theft-alarm system to malfunction and should only be serviced by an authorized
Kia dealer.
✽ NOTICE
Malfunctions caused by improper alterations, adjustments or modifications
to the theft-alarm system are not covered by your vehicle manufacturer warranty.
The alarm will be activated if any of the following occurs while the system is
armed.
A front or rear door is opened without using the ignition key or transmitter
(or smart key).
The liftga ...
Other information:
Inspection
1.
Check the battery voltage. (Low beam will be on when the battery voltage
is above 9 V.)
2.
Check the fuse and relay.
3.
Check the polarity of ballast. (The low beam will not light on in ...
Parking assist system may not operate normally when:
1. Moisture is frozen to the sensor. (It will operate normally when moisture
melts.)
2. Sensor is covered with foreign matter, such as snow or water, or the sensor
cover is blocked. (It will operate normally when the material is removed or t ...