Kia Sportage: What to do in an emergency / Road warning
Hazard warning flasher
.png)
■ Type A
.png)
■ Type B
The hazard warning flasher serves as a warning to other drivers to exercise extreme
caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle
is stopped near the edge of a roadway.
Depress the flasher switch with the ignition switch in any position. The flasher
switch is located in the center facia panel. All turn signal lights will flash simultaneously.
- The hazard warning flasher operates whether your vehicle is running or
not.
- The turn signals do not work when the hazard flasher is on.
- Care must be taken when using the hazard warning flasher while the vehicle
is being towed.
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N
(Neutral) position and then push the vehicle to a safe place.
If you h ...
Other information:
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
3.
Remove the cras ...
11. Immediately drive approximately 4~6 miles (7~10 km or, about 10 min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed
of 12 mph (20 km/h).
While driving, if you experience any unusual vibration, ride disturbance ...