Kia Sportage: Parking Brake System / Parking Brake Lever Repair procedures

Kia Sportage QL (2015-2025) Service Manual / Brake System / Parking Brake System / Parking Brake Lever Repair procedures

Removal
  
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Release a parking brake completely.
2.
Remove the floor console assembly.
(Refer to Body - "Floor console")
3.
Remove the paring brake cable (B) after removing the equalizer assembly(A).

4.
Disconnect the connector (A) of parking brake switch.

5.
Remove the parking brake lever assembly after removing the bolts (A).
Tightening torque :
19.6 - 29.4 N·m (2.0 - 3.0 kgf·m, 14.5 - 21.7 lb·ft)

Installation
1.
Installation is the reverse of removal.
  
Apply a coating of the specified grease to each sliding parts (A) of the ratchet plate or the ratchet pawl.
Specified grease:
Multi purpose grease SAE J310, NLGI No.2

2.
Conduct the 'Parking Brake Lever Stroke Adjustment'.
Adjustment
Parking Brake Lever Stroke Adjustment
1.
Install the parking brake cable adjuster, then adjust the parking brake lever stroke by turning adjusting nut (A).
Parking brake lever stroke:
6 - 7 clicks (Pull the lever with 196N (20 kgf, 44 lbf))

2.
Release the parking brake lever fully, and check that parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
3.
Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully.
Parking Brake Assembly Repair procedures
Removal Parking Brake Shoe 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from ...

Electric Parking Brake (EPB) Description and operation
Description Description of EPB The EPB is an electronic parking brake. The EPB is different from existing parking systems which operated with the brake pedal or the lever type. ...

Other information:

Kia Sportage QL (2015-2025) Service Manual: E-CVVT motor Troubleshooting


Signal Waveform • There is no separate sensor inside E-CVVT. Exhaust side 4-flank type target wheel is applied in order to compare CKPS and CMPS and calculate the valve timing. ...

Kia Sportage QL (2015-2025) Owners Manual: System operation


Ventilation 1.Set the mode to the position. 2.Set the air intake control to the outside (fresh) air position. 3.Set the temperature control to the desired position. 4.Set the fan speed control to the desired speed. Heating 1.Set the mode to the position. 2.Set the air intake control to the ...

Copyright © www.ksportagegl.com 2015-2025