Kia Sportage: BSD (Blind Spot Detection) / LCA (Lane Change Assist) / Detecting sensor
.png)
The sensors are located inside of the rear bumper.
Always keep the rear bumper clean for the system to work properly.
The system will activate when:
1. The system is on.
2. Vehicle speed is above 20 mph (32 km/h).
3. Other vehicles are detected in the rear side.
WARNING
The Blind Spot Detection System with Lane ...
• This warning message may appear when :
- There are foreign substances on the rear bumper or inside the rear bumper.
- The vehicle carries a trailer or carrier on the rear.
- Driving in rural ...
Other information:
The label located on the driver's door sill gives the original tire size, cold
tire pressures recommended for your vehicle, the number of people that can be in
your vehicle and vehicle capacity weight.
Vehicle capacity weight:
970 lbs (440 kg)
Vehicle capacity weight is the maxi ...
Inspection
1.
Measure the resistance between the terminals.
2.
If the measured resistance is not within specification, the blower resistor
must be replaced (after removing the resistor).
Replacement
...