Kia Sportage: Engine Control System / Accelerator Position Sensor (APS) Repair procedures
| 1. |
Connect the KDS/GDS on the Data Link Connector (DLC).
|
| 2. |
Turn the ignition switch ON.
|
| 3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Accelerator
Position
|
Output Voltage (V) [Vref = 5V]
|
APS1
|
APS2
|
C.T
|
0.7 - 0.8
|
0.33 - 0.43
|
W.O.T
|
3.98 - 4.22
|
1.93 - 2.17
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
terminal.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the accelerator position sensor (B) after loosening the mounting
bolts.
|
Accelerator pedal sensor mounting bolt :
8.8 - 13.7 N·m (0.9 - 1.4 kgf·m, 6.5 - 10.1 lb·ft)
|

|
| 1. |
Install in the reverse order of removal.
|
Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module
and detects the rotation angle of the accelerator pedal. The APS is one of the
most imp ...
Specification
Item
Specification
Coil Resistance (Ω)
1.18 - 1.31 [20°C(68°F)]
...
Other information:
System Circuit Diagram
Terminal Function
Housing
Pin
Function
Wire color
Pad
A
GND
Black
B
HEATER
Yellow
C
...
For maximum restraint system protection, the seat belts must always be
used whenever the vehicle is moving. A properly positioned shoulder belt should
be positioned midway over your shoulder across your collarbone.
Never allow children to ride in the front passenger seat. See child restra ...