Kia Sportage: Warning lights / Engine Oil Pressure Warning Light
.png)
This warning light illuminates:
- Once you set the ignition switch or Engine Start/Stop Button to the ON
position.
- It remains on until the engine is started.
- When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details, refer
to “Engine Oil” in chapter 8). If the level is low, add oil as required.
If the warning light remains on after adding oil or if oil is not available,
have your vehicle inspected by an authorized Kia dealer as soon as possible.
CAUTION - Engine damage
If the engine is not stopped immediately after the engine oil pressure warning
light is illuminated and stays on while the engine is running, serious engine damage
may result.
If the warning light stays on while the engine is running, it indicates that
there may be serious engine damage or malfunction. In this case,
1. Stop the vehicle as soon as it is safe to do so.
2. Turn off the engine and check the oil level. If the oil level is low, fill
the engine oil to the proper level.
3. Start the engine again. If the warning light stays on after the engine is
started, turn the engine off immediately. In this case, have your vehicle inspected
by an authorized Kia dealer.
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON
position.
- It remains on until the engine is started.
When there is a malfunction w ...
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON
position.
- It illuminates for approximately 3 seconds and then goes off.
When one o ...
Other information:
The High Beam Assist is a system that automatically adjusts the headlamp range
(switches between high beam and low beam) according to the brightness of other vehicles
and road conditions.
Operating condition
1.Place the light switch in the AUTO position.
2.Turn on the high beam by pushing t ...
To install a LATCH-compatible child restraint in either of the rear outboard
seating positions:
1. Move the seat belt buckle away from the lower anchors.
2. Move any other objects away from the anchors that could prevent a secure connection
between the child restraint and the lower anchors.
3 ...