Kia Sportage: Tire Sealant and Inflator Kit (IF EQUIPPED) / What to do after the Tire has been Sealed

Lincoln Corsair Owners Manual / Wheels and Tires / Tire Sealant and Inflator Kit (IF EQUIPPED) / What to do after the Tire has been Sealed

After using the kit to seal your tire, you will need to replace the sealant canister. Sealant canisters and spare parts can be obtained at an authorized Ford dealer. Empty sealant canisters may be disposed of at home. However, canisters still containing liquid sealant should be disposed of by your local authorized Ford dealer or tire dealer, or in accordance with local waste disposal regulation.

Note: After the sealing compound has been used, the maximum vehicle speed is 50 mph (80 km/h) and the maximum driving distance is 120 mi (200 km). The sealed tire should be inspected immediately.

You can check the tire pressure any time within the 120 mi (200 km) by performing the steps listed previously in the Second stage: Checking Tire Pressure procedure.

Removal of the sealant canister from the kit

Lincoln Corsair. What to do after the Tire has been Sealed

  1. Unwrap the dual purpose hose (black tube) from the compressor housing.

    Lincoln Corsair. What to do after the Tire has been Sealed

  2. Unwrap the power cord.

    Lincoln Corsair. What to do after the Tire has been Sealed

  3. Remove the back cover.

    Lincoln Corsair. What to do after the Tire has been Sealed

  4. Rotate the sealant canister up 90 degrees and pull away from casing/housing to remove.

Installation of the sealant canister to the kit

  1. With the canister held perpendicular to the housing, insert the canister nozzle into the connector and push until seated.
  2. Rotate the canister 90 degrees down into the housing/casing.

    Lincoln Corsair. What to do after the Tire has been Sealed

  3. Snap the back cover back into place.

    Lincoln Corsair. What to do after the Tire has been Sealed

  4. Wrap the dual purpose hose (black tube) around the channel on the bottom of the housing/casing.

    Lincoln Corsair. What to do after the Tire has been Sealed

  5. Wrap the power cord around the housing and stow the accessory power plug into its storage area.

Note: If you experience any difficulties with the removal or installation of the sealant canister, consult your authorized Ford dealer for assistance.

Be sure to check the sealant compound’s use-by date regularly. The use-by date is on a label located on the sealant canister and can be seen through the rectangular viewing window on the bottom of the kit. The sealant canister should be replaced when the sealant expires.

Second Stage: Checking Tire Pressure
WARNING: If the tire does not inflate to the recommended tire pressure within 15 minutes, stop and call roadside assistance. WARNING: The power plug may get hot after use and should be handled ca ...

Tire Care
...

Other information:

Kia Sportage QL (2015-2021) Service Manual: Panorama Sunroof Deflector Repair procedures


Replacement 1. Completely open the movable glass using the panorama sunroof switch. 2. Loosen he mounting screws (A) located at the side of the panorama sunroof deflector.    ...

Kia Sportage QL (2015-2021) Service Manual: Positive Crankcase Ventilation (PCV) Valve Repair procedures


Removal 1. Disconnect the PCV hose (A). 2. Remove the PCV valve (B). Inspection 1. Insert a thin stick (A) into the PCV valve (B) from the threaded side to check that the plunger ...

Copyright © www.ksportagegl.com 2015-2021